How To Repair A Maytag Dryer Mgdc415ew1

We're pitiful, but our Q&A experts are temporarily unavailable.
Please check back afterwards if you still haven't establish the reply you lot need.

Make humming racket when pressing offset button. Would not beginning

After looking on the website for advice I walked throught the simple steps of disassembling the front, removing the drum, removed the back, disconnected the wire harness. Then removed the blower housing in the back. The blower, mounted on the dorsum side of the motor was very tight. I used a pipe wrench wedged in place and help by my 10 year old G-girl while I used an adaptable wrench to turn the shaft on the forepart of the motor. Spun the blower off, removed the two clips holding the motor. Then reversed the process when I received the new motor. Care should be taken to avoid damaging the blower fan if a lot of pressure level is required.

Parts Used:

• 
• 
• 

  Total Repair Time:

  xxx - 60 mins

• 

  Tools:

  Nutdriver, Screw drivers

88 of 100 people constitute this pedagogy helpful.

Was this teaching helpful to you lot?

Thank you lot for voting!

Push to Start switch burned out due to electrical problem

Unplug from the wall ,remove upper back panel ( watch out for the grounding wire screwed to the panel), pulled off front end knob, and so twist and pull the switch out. Unplug the burned out switch, plugged in the new i. Re-assembled what I took apart, plugged her upward and dried the load that was in the washer. Annotation: if yours is burned out due to house power surge make certain the timer is working later you supercede the switch, y'all might need one of thoes too.

Parts Used:

• 
• 

  Difficulty Level:

  Actually Piece of cake

• 

  Total Repair Fourth dimension:

  Less than 15 mins

• 

89 of 104 people found this education helpful.

Was this instruction helpful to you?

Give thanks you for voting!

Bought motor, and then bought blower bike also

couldn't go blower wheel off of the motor. really tight. rounded off the wheel'southward foursquare hub while trying to hold it still as I turned the motor shaft out. No, I wasn't turning it the wrong way :) I ended up going to the back of the dryer and using the multimax to quickly cutting the bike away from the hub. I love that oscillating saw! Just for fun, I put the motor in a bench vise and got the wheel hub off (in pieces). VERY tight! Ordered new cycle, and the job was smooth sailing from at that place on. I am guessing that experienced repair people automatically guild the motor and blower wheel at the aforementioned time(?) BTW both parts were perfect matches for the originals. Not surprised; this has always been my experience with partselect.com!

Parts Used:

• 

  Daniel from Coatesville, PA

• 
• 

  Total Repair Time:

  More than 2 hours

• 

  Tools:

  Nutdriver, Screw drivers, Wrench (Adjustable)

86 of 101 people found this instruction helpful.

Was this education helpful to you?

Thanks for voting!

Source: https://www.partselect.com/Models/MGDC415EW1/

Posted by: hansonnotne1961.blogspot.com

Share this post